Angle grinders and rotary tools are effective ways to cut tile while it s still glued to the wall or floor.
Tile saw chipping.
A great way to avoid chipping on porcelain tiles is to notch the tile before cutting through.
Set your tile saw blade upon the tile.
Set your blade so that this time it will cut through the whole remaining thickness of the tile.
Turn on the saw push the tile slowly through the blade and get the shallow cut done.
To make a notch on the end of your tile.
If it is a small tile cut only 1 inch in from the.
To notch the tile follow these steps.
Fix a piece of masking tape along the mark to make the line easier to follow and help prevent chipping.
Mark the point where you wish to notch.
Use a spray bottle to wet the tile with water to reduce dust.
Cut a 1 in 2 5 cm line along your mark with the tile face down.
Mark your tile where you want the notch to be.
Turn on your saw using the switch on the side of the front of the saw.
Guide the saw forward until you cut 1 in 2 5 cm in from the edge.
Chipping tile when cutting with a saw happens because the blade gets worn.
You have to be very patient in cutting tiles whether it is a wet saw or a manual tile cutter.
Mark the location of the cut with a marker or pencil.
Make sure the tile doesn t touch the blade before doing this.
One way to avoid chipping your porcelain tile is to notch the tile before you cut through it.
Flip your tile over so the finished side faces the bottom of your saw.
Do not touch the blade to the tile.
I will show you what yo.
If you push the tile too fast towards the cutter you ll increase your chances of chipping the tile.
Push the tile into the saw blade approximately 1 or 2 inches depending on the size of the tile then back the tile out and turn off the saw.
A little wobble or slight off centering of the blade to the arbor will create chipping.
Set your tile on the platform with the mark facing your diamond blade.
Set your blade to cut all the way through the tile.
Turn the saw on.
After you ve done this you can either cut through the whole tile or cut a notch into one end and then cut the whole tile.
Turn on your saw.
This way you will prevent chipping even more.
If the wet saw s tray moves toward the cutter slowly cut the tile towards the blade and ensuring that the saw is constantly getting sprayed with water from the pump.
Place the tile with the marking facing the blade but do not let them get in touch yet and turn on your saw.
