Spring Adjustment Garage Door

Torsion springs must be adjusted with the door in the down position.

Spring adjustment garage door.

Adjusting garage door springs is a common repair. One end of the spring is connected to the garage door track or frame. If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments. Adjusting garage door extension.

Garage door springs are used to offset the weight of the door. The springs are located at the top inside part of the garage door. If adjustment of the rear track hanger is necessary the door must be locked in the closed position because the weight of the door is supported by the rear hangers. If the door was closing too quickly move the spring to the next higher hole on the bracket.

The torsion spring helps the garage door open and close easily. How to safely adjust your garage door spring. Troubleshooting garage door springs. Both the winding and stationary cones are professionally installed for safe operation.

When garage doors won t close all of the way or they close unevenly spring adjustment may be called for. This can make the other parts of the garage door last a much longer time. Be sure to have all your tools inside before closing the door unless you have an alternate access door to the garage. Detach the old spring from both ends and replace it with the new one and replace the pulleys as well if they are worn out.

Adjustment to torsion springs can be dangerous because they must be adjusted with the door down and the spring under tension. Adjust the springs on both sides of the door the same way. Adjust the spring into the proper position and make sure your garage door closes all of the way. All dura lift springs meet the dasma standard rating of 10 000 plus door open and close cycles.

Garage door springs offset the weight of the door and allow it to open and close with ease. Retest the door balance as you did in step 1. Without the springs the door is very difficult to lift. This video applies t.

Once the spring is free of tension remove from its track hanger. If the torsion springs do not increase in tension as the 1 4 turns are added to the springs then you probably have the torsion springs reversed. If it was opening too quickly move it to the next lower hole. The other is attached to a pulley connected to the cable.